English (United Kingdom)

https://curated-unify.zendy.io/wp-json/zendy-region/v1/featured_content/oa?rat=en

https://curated-unify.zendy.io/wp-json/zendy-region/v1/highlighted_journal/

Global: Zendy Plus annual

Presents the access of premium content as premium feature

Premium Content

Presents the keyphrase highlighting as premium feature

Keyphrase Highlighting

Presents the summarisation as premium feature

Summarisation

Insights

Presents the pdf analysis as premium feature

PDF Analysis

Presents the zaia usage as premium feature

ZAIA

Global: Zendy Tools annual

Global: Zendy Free Plan

Global: Zendy Tools monthly

Global: Zendy Plus monthly

Most mechanical systems (in particular, gear transmission system) undergo relative motion which results in increased friction phenomenon (friction coefficient, stresses, and wear rate) and thereby results in loss of efficiency. Mechanical parts undergo relative motion in different geometry configurations and orientations that induce a different state of stress as a result of friction. Till date, attempts are being made to minimize the friction with full sphere pin geometry configuration. The present work focused to reduce the frictional and wear rate, and experiments are conducted with tribo-pairs. i.e., nickel-coated pin surface slide against Al6061 alloy disc. The friction studies are carried out at different loads and geometries of pin surfaces (sphere and hemisphere configured at different orientations such as full sphere and hemisphere configured at 0°, 45°, and 90°) to induce different stress states with reference to sliding directions. Change in the geometry of EN8 pin material and their orientation with reference to sliding direction resulted in a different state of stress. The resulting stress levels were examined under the scanning electron microscope, which revealed the mechanisms of adhesion, abrasion, and extrusion. At a lower magnitude of orientation and load, the extent of asperity breaking lessens and material removal from pin surface decreases. Abrasion wear mechanism was observed corresponding to full sphere configuration on Al 6061 disc, whereas adhesive wear mechanisms are seen with hemisphere pins. The amount of aluminum transfer on pin surface with a hemisphere pin is comparatively more than that of full sphere configuration. At a lower magnitude of state of stress, the mechanism of sliding was dominated by the adhesion effect. At a higher level of state of stress, the mechanism of sliding was dominated by abrasion and extrusion.

Effect of Pin Geometry and Orientation on Friction and Wear Behavior of Nickel-Coated EN8 Steel Pin and Al6061 Alloy Disc Pair