Free-field reciprocity calibration of laboratory standard (LS) microphones using a time selective technique

Although the basic principle of reciprocity calibration of microphones in a free field is simple, the practical problems are complicated due to the low signal‐to‐noise ratio and the influence of cross talk and reflections from the surroundings. The influence of uncorrelated noise can be reduced by conventional narrow‐band filtering and time averaging, while correlated signals like cross talk and reflections can be eliminated by using time‐selective postprocessing techniques. The technique used at DPLA overcomes both these problems using a B&K Pulse analyzer in the SSR mode (steady state response) and an FFT‐based time‐selective technique. The complex electrical transfer impedance is measured in linear frequency steps from a few kHz to about three times the resonance frequency of the microphones. The missing values at low frequencies are estimated from a detailed knowledge of the pressure sensitivities. Next an inverse FFT is applied and a time window around the main signal is used to eliminate cross talk ...