Response to “Comment on ‘Observation of nuclear gamma resonance with superconducting tunnel junction detectors’” [AIP Advances 9, 059101 (2019)]

The Comment contains two main claims, which we consider in detail below. The first claim is that our results are erroneous because in order to observe the Mössbauer effect at zero relative velocity of the source and the absorber V = 0, it is necessary that they have single emissionabsorption lines, whereas in our work the scatterer with a splitted Mössbauer spectrum was used. We cannot agree with this point of view. Recall that Mössbauer effect or nuclear gamma resonance (NGR) is the resonant and recoil-free emission and absorption of gamma radiation by atomic nuclei bound in a solid. Deexcitation of excited Mössbauer nucleus is accompanied not only by emission of gamma radiation but also by emission of X-rays and resonant (conversion and Auger) electrons. It is evident that to observe the Mössbauer effect at V = 0 using the source with a single line and the scatterer with a splitted Mössbauer spectrum it is sufficient to have a nonzero value of the resonant absorption in the scatterer. This effect can be seen clearly in the absorption spectrum given in Figure 3c of the Comment for the alloy Rh0.8Fe0.2 used in our work. Due to the overlap of inner neighboring lines, the value of the effect at V = 0 exceeds 20% of the maximum value for the outermost lines of the spectrum. Thus, the effect is noticeable at V = 0 but is absent at high velocities (larger than ± 4.5 mm/s). Since the conversion coefficient of the Mössbauer transition in 57Fe nucleus is large, the absorption of Mössbauer gamma-quanta in the scatterer results in a large number of conversion electrons (approximately nine electrons for each emitted gamma-quantum) and corresponding number of Auger electrons which are registered by the superconducting tunnel junction (STJ) detector in addition to X-rays. Therefore, the assumption made in the Comment that there must be single peaks both in the source and the scatterer and all subsequent statements based on it are incorrect. All our experiments have been performed very carefully with great attention to their reproducibility and repeatability, and we are confident in the results published in our paper. Notice that in our study we have presented spectra with (Rh0.8Fe0.2) and without (Rh) the Mössbauer effect. Direct comparison of these spectra clearly demonstrates that peaks 2 and 4 in Figure 2(a) and analogous peaks in Figure 4(a) of our article can be ascribed only to resonance electrons appearing as a result of the Mössbauer effect in the scatterer and we cannot suggest alternative explanation for these signals. The absence of pronounced peaks in the remote detector number 2 is accounted for by the attenuation of the electron flow and the change of the regime of electron proliferation from directional to diffusion at distances of the order of 1 mm. This is explained in more detail in paragraph 3 of our article where we give estimations for electron ranges. The second claim in the Comment is that the STJ detectors have no application prospects in Mössbauer spectroscopy and more specifically for spectroscopy on 57Fe and 119Sn isotopes. In fact that is the main issue discussed in the Comment and the arguments are as follows: small thickness of the absorbers, low absorption probability, low area of detectors, absence of total absorption peak etc.