Open AccessActive arc suppression device based on voltage‐source convertor with consideration of line impedance in distribution networks
Author(s) -
Fan Bishuang,
Ma Haihang,
Wang Wen,
Yao Ganzhou,
Li Qikai,
Zeng Xiangjun,
Guerrero Josep M.
Publication year - 2021
Publication title -
iet power electronics
Language(s) - English
Resource type - Journals
SCImago Journal Rank - 0.637
H-Index - 77
eISSN - 1755-4543
pISSN - 1755-4535
DOI - 10.1049/pel2.12203
Subject(s) - voltage drop , fault (geology) , electrical impedance , ground , engineering , line (geometry) , electrical engineering , voltage , current (fluid) , fault current limiter , power (physics) , control theory (sociology) , electronic engineering , electric power system , computer science , physics , geometry , mathematics , control (management) , quantum mechanics , artificial intelligence , seismology , geology
In the non‐effectively grounding distribution system, residual current under single‐line‐to‐ground (SLG) fault threatens the safety of human being and power supply equipment. Active arc suppression device has been proved to be effective for SLG fault arc suppression when the line impedance is ignored. However, in practice, line impedance varies with the fault location and the load current flowing through the impedance brings about additional voltage drop, which increases the fault current and is not dealt with by the conventional methods. To achieve accurate SLG fault arc suppression with the existence of line impedance, the neutral‐to‐ground voltage reference for full ground‐fault current compensation is firstly derived and a detection method is then proposed. The pre‐fault and post‐fault line currents are used to eliminate the influence of load current on the line impedance voltage drop. A dual‐loop voltage and current controller is then designed. The prototype of active arc suppression device was developed. The results of simulation and prototype experiment validate the effectiveness of the proposed method.