Effect of Sodium Bromide on CaO-Based Sorbents Derived from Three Kinds of Sources for CO2 Capture

The calcium looping (CaL), which applies carbonation/calcination cyclic reactions of a CaO sorbent, has received extensive attention for postcombustion CO 2 capture. However, as the number of cyclic reactions increased, the capture efficiency of regenerated CaO decreased rapidly. Sodium doping was proposed for modification of a CaO sorbent, but there was little research on whether sodium doping had a good effect on different kinds of sorbents. In this paper, three different kinds of calcium-based sorbents, i.e., CaCO 3 , dolomite, and SG-CaO, were modified by NaBr to explore the effect of sodium on CO 2 capture performance. The results showed that the modification effects of sodium on three kinds of precursors were different. For CaCO 3 , the modification effect of sodium doping was the best. After 50 cycles, the sorption capacity of CaO/NaBr was over 3.5 times that of an unmodified sorbent; for dolomite, sodium had a moderate effect during initial cycles and then showed obvious improvement in the stability of the sorbent, the sorption capacity of the modified dolomite increased by over 30% after 50 cycles; for the SG-CaO, sodium had a negative effect, the sorption capacity of the modified sorbent decreased by about 30% after 50 cycles. When the atmosphere contained SO 2 , the doping of an alkali metal also showed a certain effect.