English (United Kingdom)

https://curated-unify.zendy.io/wp-json/zendy-region/v1/featured_content/oa?rat=en

https://curated-unify.zendy.io/wp-json/zendy-region/v1/highlighted_journal/

Zendy Plus

Presents the access of premium content as premium feature

Premium Content

Presents the keyphrase highlighting as premium feature

Keyphrase Highlighting

Presents the summarisation as premium feature

Summarisation

Insights

Presents the pdf analysis as premium feature

PDF Analysis

Presents the zaia usage as premium feature

ZAIA

Zendy Tools

Zendy Open

The current study introduces a two-terminal (2T) thin-film tandem solar cell (TSC) comprised of a polymer-based top sub cell and a thin crystalline silicon (c-Si) bottom sub cell. The photoactive layer of the top sub cell is a blend of PDTBTBz-2F as a polymer donor and PC 71 BM as a fullerene acceptor. Initially, a calibration of the two sub cells is carried out against experimental studies, providing a power conversion efficiency (PCE) of 9.88% for the top sub cell and 14.26% for the bottom sub cell. Upon incorporating both sub cells in a polymer/Si TSC, the resulting cell shows a PCE of 20.45% and a short circuit current density ( J  sc ) of 13.40 mA/cm 2 . Then, we optimize the tandem performance by controlling the valence band offset (VBO) of the polymer top cell. Furthermore, we investigate the impact of varying the top absorber defect density and the thicknesses of both absorber layers in an attempt to obtain the maximum obtainable PCE. After optimizing the tandem cell and at the designed current matching condition, the J  sc and PCE of the tandem cell are improved to 16.43 mA/cm 2 and 28.41%, respectively. Based on this TCAD simulation study, a tandem configuration established from an all thin-film model may be feasible for wearable electronics applications. All simulations utilize the Silvaco Atlas package where the cells are subjected to standard one Sun (AM1.5G, 1000 W/m 2 ) spectrum illumination.

Investigation of Polymer/Si Thin Film Tandem Solar Cell Using TCAD Numerical Simulation