English (United Kingdom)

https://curated-unify.zendy.io/wp-json/zendy-region/v1/featured_content/oa?rat=en

https://curated-unify.zendy.io/wp-json/zendy-region/v1/highlighted_journal/

Global: Zendy Plus annual

Presents the access of premium content as premium feature

Premium Content

Presents the keyphrase highlighting as premium feature

Keyphrase Highlighting

Presents the summarisation as premium feature

Summarisation

Insights

Presents the pdf analysis as premium feature

PDF Analysis

Presents the zaia usage as premium feature

ZAIA

Global: Zendy Tools annual

Global: Zendy Free Plan

Global: Zendy Tools monthly

Global: Zendy Plus monthly

Carburized samples were prepared under different sets of conditions at Millat Equipment Limited, Lahore, Pakistan, using continuous carburizing furnace under a reducing atmosphere. The gas carburizing process parameters were determined by the Taguchi design of experiment (DoE), an orthogonal array of L9 type with the mixed level of control factors. The key process parameters in gas carburizing process such as delay quenching interval, hardening temperature, and soaking time in oil were optimized in terms of core hardness, effective case depth (ECD), and surface hardness. DoE approach elucidated that the best results in terms of core hardness are A2 (delay quenching for 60 seconds), B2 (hardening temperature of 800°C), and C2 (soaking in quenching oil for 300 seconds). However, the best results in terms of ECD were A1 (delay quenching for 45 seconds), B3 (hardening temperature of 820°C), and C1 (soaking in quenching oil for 180 seconds). In order to choose the optimized parameters from the results given by DoE, microscopic analysis was conducted. Microscopic analysis showed coarse bainitic structure in core and tempered martensite at the surface of the samples processed at A2 (delay quenching for 60 seconds), B2 (hardening temperature of 800°C), and C1 (soaking in quenching oil for 180 seconds) compared to the other process conditions (A1, B3, and C1), which shows fine bainitic structure at core and relatively higher amount of retained austenite at the surface. Finally, defect per million opportunities (DPMO) model exhibited that the samples produced from the optimized set of parameters (A2, B2, and C1) are highly reproducible, gaining DPMO of 83 parts per million (PPM).

Design of Experiment Approach in the Industrial Gas Carburizing Process