English (United Kingdom)

https://curated-unify.zendy.io/wp-json/zendy-region/v1/featured_content/oa?rat=en

https://curated-unify.zendy.io/wp-json/zendy-region/v1/highlighted_journal/

Global: Zendy Plus annual

Presents the access of premium content as premium feature

Premium Content

Presents the keyphrase highlighting as premium feature

Keyphrase Highlighting

Presents the summarisation as premium feature

Summarisation

Insights

Presents the pdf analysis as premium feature

PDF Analysis

Presents the zaia usage as premium feature

ZAIA

Global: Zendy Plus monthly

Global: Zendy Tools annual

Global: Zendy Tools monthly

Global: Zendy Free Plan

Parallel manipulators (PMs) are closed kinematic chains with one or more loops where only some pairs are actuated while the remaining are passive. In particular, they feature a fixed link (base) and an output moving link (platform) interconnected by at least two independent kinematic chains (legs) to form one loop. The most well known and commonly employed PMs (hereafter called UPS-PMs) feature n variable-length legs of type UPS (where U, P and S are for universal, spherical and prismatic pairs respectively). Equivalently, a revolute pair R could be used instead of the prismatic pair P in order to make the leg length variable (in this case the leg would be of type URS). These leg topologies provide the platform with six degrees of freedom with respect to the base. Although the definition of UPS-PMs requires n ≥ 2, in practice, neglecting overconstrained and redundantly-actuated manipulators, performance issues recommend 3 ≤ n ≤ 6. Indeed, UPS-PMs with only two UPS legs might exhibit a low stiffness against torques acting along the line joining the centers of the two spherical pairs, and their control would require the inseries placement of at least three actuators/sensors (one of them placed to control/measure at least one out of the three degrees of freedom of the spherical pairs) which reduces the overall manipulator dynamic and accuracy capabilities. On the other side, the use of more than six legs reduces the exploitable manipulator workspace for the increase of leg interference. Different sub-classes of manipulator architectures can be obtained according to the location of the centers of the U and S pairs in the base and in the platform respectively (Innocenti & Parenti-Castelli, 1994; Faugere & Lazard, 1995). General UPS-PM architectures feature distinct joint centers. Special architectures can be devised by setting some of the joint centers to be coincident. A schematic of a 6-DOF UPS-PM having six legs (n = 6) and general architecture is shown in Fig. 1. In the figure, the U pairs (connecting the legs to the base) and S pairs (connecting the legs to the platform) are depicted as grey and white dots respectively. Points Bi and Pi represent the centers of the U and S pairs of the i-th leg on the base and on the platform respectively. The six legs of type UPS are represented by the telescopic rods BiPi (i = 1, ..., 6). Accordingly, the length of the i-th leg is defined as the distance li = ⎪Pi Bi⎪.

Robust, Fast and Accurate Solution of the Direct Position Analysis of Parallel Manipulators by Using Extra-Sensors