English (United Kingdom)

https://curated-unify.zendy.io/wp-json/zendy-region/v1/featured_content/oa?rat=en

https://curated-unify.zendy.io/wp-json/zendy-region/v1/highlighted_journal/

Global: Zendy Plus annual

Presents the access of premium content as premium feature

Premium Content

Presents the keyphrase highlighting as premium feature

Keyphrase Highlighting

Presents the summarisation as premium feature

Summarisation

Insights

Presents the pdf analysis as premium feature

PDF Analysis

Presents the zaia usage as premium feature

ZAIA

Global: Zendy Plus monthly

Global: Zendy Tools annual

Global: Zendy Tools monthly

Global: Zendy Free Plan

Cast Al-Si-Cu-Mg and Al-Cu-Ni-Mg alloys have a widespread application, especially in the marine structures, automotive and aircraft industry due to their excellent properties. The main alloying elements – Si, Cu, Mg and Ni, partly dissolve in the primary α-Al matrix, and to some extent present in the form of intermetallic phases. A range of different intermetallic phases may form during solidification, depending upon the overall alloy composition and crystallization condition. Their relative volume fraction, chemical composition and morphology exert significant influence on a technological properties of the alloys (MrowkaNowotnik G., at al., 2005; Zajac S., at al., 2002; Warmuzek M., at al. 2003). Therefore the examination of microstructure of aluminium and its alloys is one of the principal means to evaluate the evolution of phases in the materials and final products in order to determine the effect of chemical composition, fabrication, heat treatments and deformation process on the final mechanical properties, and last but not least, to evaluate the effects of new procedures of their fabrication and analyze the cause of failures (Christian, 1995; Hatch, 1984; Karabay et al., 2004). Development of morphological structures that become apparent with the examination of aluminium alloys microstructure arise simultaneously with the freezing, homogenization, preheat, hot or cold reduction, anneling, solution and precipitation heat treatment of the aluminium alloys. Therefore, the identification of intermetallic phases in aluminium alloys is very important part of complex investigation. These phases are the consequence of equilibrium and nonequilibrium reactions occurred during casting af aluminium alloy. It worth to mention that good interpretation of microstructure relies on heaving a complete history of the samples for analysis. Commercial aluminium alloys contains a number of second-phase particles, some of which are present because of deliberate alloying additions and others arising from common impurity elements and their interactions. Coarse intermetallic particles are formed during solidification in the interdendric regions, or whilst the alloy is at a relatively high temperature in the solid state, for example, during homogenization, solution treatment or recrystallization (Cabibbo at al., 2003; Gupta at al., 2001; Gustafsson at al., 1998; Griger at al., 1996; Polmear, 1995; Zhen at al., 1998). They usually contain Fe and other alloying elements

Intermetallic Phases Examination in Cast AlSi5Cu1Mg and AlCu4Ni2Mg2 Aluminium Alloys in As-Cast and T6 Condition