English (United Kingdom)

https://curated-unify.zendy.io/wp-json/zendy-region/v1/featured_content/oa?rat=en

https://curated-unify.zendy.io/wp-json/zendy-region/v1/highlighted_journal/

Global: Zendy Plus annual

Presents the access of premium content as premium feature

Premium Content

Presents the keyphrase highlighting as premium feature

Keyphrase Highlighting

Presents the summarisation as premium feature

Summarisation

Insights

Presents the pdf analysis as premium feature

PDF Analysis

Presents the zaia usage as premium feature

ZAIA

Global: Zendy Tools annual

Global: Zendy Free Plan

Global: Zendy Tools monthly

Global: Zendy Plus monthly

The influence of molybdenum concentration and resin amount on the retention of molybdenum in 5M NaOH on DowexTM-1 columns with successive elutions of saline and tetrabutylammonium bromide (TBAB) was investigated. Studies were performed with 45, 75, 125, 175, or 250 mg of resin and at 100 and 250 mg/mL molybdenum concentrations. Initial pass-through molybdenum recoveries from the column were 97.8% at 100 mg/L and 97.8% at 250 mg/mL (n=3 at each resin amount). Molybdenum breakthrough into TBAB solvent was low for all five resin amounts. Values for the 100mg/mL solution were 0.33 – 3.73 ppm, representing 0.0002 - 0.0014% of the original molybdenum load; and were 0.96 - 11.27 ppm for the 250 mg/mL solution, equivalent to 0.0002 – 0.0027%. Breakthrough into TBAB is generally higher with higher resin amounts for both the 100 mg/ml and 250 mg/mL molybdenum concentrations. The resin can be used for high molybdenum loads, with care taken to optimize the relative resin-solute amounts.

Recovery Profiles of Molybdate Solutions Through Varying DowexTM-1 Resin Amounts, and Translation to Mo99/Tc99m Separation