English (United Kingdom)

https://curated-unify.zendy.io/wp-json/zendy-region/v1/featured_content/oa?rat=en

https://curated-unify.zendy.io/wp-json/zendy-region/v1/highlighted_journal/

Global: Zendy Plus annual

Presents the access of premium content as premium feature

Premium Content

Presents the keyphrase highlighting as premium feature

Keyphrase Highlighting

Presents the summarisation as premium feature

Summarisation

Insights

Presents the pdf analysis as premium feature

PDF Analysis

Presents the zaia usage as premium feature

ZAIA

Global: Zendy Tools annual

Global: Zendy Free Plan

Global: Zendy Tools monthly

Global: Zendy Plus monthly

Trim cutting operation in wire electrical discharge machining (WEDM) is considered as a probable solution to improve surface characteristics and geometrical accuracy by removing very small amount of work materials from the surface obtained after a rough cutting operation. In this study, an attempt has been made to model the surface roughness and dimensional shift in trim cutting operations in WEDM process through response surface methodology (RSM). Four process parameters; namely pulse-on time (Ton), servo voltage (SV), wire depth (Wd) and Dielectric flow rate (FR) have been considered as input parameters in trim cutting operations for modelling. Desirability function has been employed to optimize multi performance characteristics. Increasing the value of Ton, Wd and FR increases the surface roughness and dimensional shift but increasing SV decreases both surface roughness and dimensional shift. Quadratic models have been proposed for both the performance characteristics. In present experimentation, thickness of recast layer was observed in the range of 6μm to 12μm for low to high value of discharge parameters

An experimental investigation and statistical modelling for trim cutting operation in WEDM of Nimonic-90