English (United Kingdom)

https://curated-unify.zendy.io/wp-json/zendy-region/v1/featured_content/oa?rat=en

https://curated-unify.zendy.io/wp-json/zendy-region/v1/highlighted_journal/

Global: Zendy Plus annual

Presents the access of premium content as premium feature

Premium Content

Presents the keyphrase highlighting as premium feature

Keyphrase Highlighting

Presents the summarisation as premium feature

Summarisation

Insights

Presents the pdf analysis as premium feature

PDF Analysis

Presents the zaia usage as premium feature

ZAIA

Global: Zendy Tools annual

Global: Zendy Free Plan

Global: Zendy Tools monthly

Global: Zendy Plus monthly

The structural-phase state and tribotechnical properties of gas-thermal coatings made of Ni-Cr-Al pseudoalloy are investigated in the initial state and after annealing in the temperature range of 550-650 °С with holding time of 20–60 min. It is shown that in coatings sprayed by the method of high-speed metallization of wires made of Х20Н80 (Kh20N80) and aluminum АД-1 (AD-1), the phase composition includes γ-(Ni, Cr, Fe), Al and Al2O3. It is found that high-temperature annealing of Ni-Cr-Al coatings leads to the precipitation of intermetallic compounds Al3Ni, Ni2Al3, Ni3Al, and NiAl in them, as well as to an increase in the porosity of the coatings up to ≈15–20 vol.%, which is associated with the implementation of the Frenkel and Kirkendall effects. Tribotechnical tests of coatings are carried out according to the scheme of the reciprocating movement of the sample along the plate counterbody in the dry friction mode at a load of 1.5 MPa. It is shown that as a result of the annealing of the coatings, an increase in their wear resistance under dry friction conditions is registered up to 24 times in comparison with the initial state. In particular, the intensity of mass wear of the Ni-Cr-Al coating in the initial state is 28.7 × 10–3 mg/m, and those subjected to annealing at 600 °C for 60 min — 1.2 × 10–3 mg/m. Based on the carried out multifactorial experiment, it is found that the maximum wear resistance of Ni-Cr-Al-pseudo-alloy coatings under dry friction conditions is achieved as a result of their annealing at temperatures of 630–640 °С and a holding time of 40–50 min, which is associated with the release of large number of dispersed intermetallic phases Ni3Al and NiAl with a relatively insignificant increase in the porosity of the coatings.

INFLUENCE OF THE ANNEALING ON THE WEAR RESISTANCE OF GAS-THERMAL COATINGS FROM Ni-Cr-Al PSEUDOALLOY