English (United Kingdom)

https://curated-unify.zendy.io/wp-json/zendy-region/v1/featured_content/oa?rat=en

https://curated-unify.zendy.io/wp-json/zendy-region/v1/highlighted_journal/

Global: Zendy Plus annual

Presents the access of premium content as premium feature

Premium Content

Presents the keyphrase highlighting as premium feature

Keyphrase Highlighting

Presents the summarisation as premium feature

Summarisation

Insights

Presents the pdf analysis as premium feature

PDF Analysis

Presents the zaia usage as premium feature

ZAIA

Global: Zendy Plus monthly

Global: Zendy Tools annual

Global: Zendy Tools monthly

Global: Zendy Free Plan

The aim of this study was to investigate the effect of post-machining sintering on marginal and internal fit of CAD/CAM-fabricated zirconia frameworks. Single crown copings (A: abutment), three-unit bridge frameworks (APA, P: pontic), four-unit bridge frameworks (APPA), and five-unit bridge frameworks (A1P1A2P2A3) were fabricated with raw-stage zirconia blanks using a commercial CAD/CAM system (KATANA, Noritake Dental Supply Co. Ltd., Aichi, Japan). Crown copings and frameworks were cemented to their respective master abutment models, and thickness of the cement layer was measured at specific measuring points. Marginal and internal fit of both APA and APPA were within clinical acceptance. However, the marginal gap and thickness of the cement layer on the axial surface of the pontic side of APA and APPA were slightly higher than those of the non-pontic side. As for the marginal gap of A1P1A2P2A3 framework, it was superior to those of APA and APPA because the center abutment supported the framework to prevent distortion.

Effect of Sintering on the Marginal and Internal Fit of CAD/CAM-fabricated Zirconia Frameworks