English (United Kingdom)

https://curated-unify.zendy.io/wp-json/zendy-region/v1/featured_content/oa?rat=en

https://curated-unify.zendy.io/wp-json/zendy-region/v1/highlighted_journal/

Global: Zendy Plus annual

Presents the access of premium content as premium feature

Premium Content

Presents the keyphrase highlighting as premium feature

Keyphrase Highlighting

Presents the summarisation as premium feature

Summarisation

Insights

Presents the pdf analysis as premium feature

PDF Analysis

Presents the zaia usage as premium feature

ZAIA

Global: Zendy Tools annual

Global: Zendy Free Plan

Global: Zendy Tools monthly

Global: Zendy Plus monthly

The article presents the first data on EK-164ID steel swelling after operational irradiation in a fast nuclear reactor in the temperature range of 370–630 °C and maximum damaging doses of 66–77 dpa. The dose accumulation rate along the cladding tubes made of this material was 1×10 -8 –1.6×10 -6  dpa/s. The swelling was determined by the hydrostatic weighing method with an error of no more than 0.5%. The results obtained were analyzed depending on the irradiation parameters and in comparison with the 16Cr-15Ni grade material. The objectives of the study were to estimate the characteristic values of the maximum swelling temperature and dose as well as to calculate the average material swelling rate at the working temperature of irradiation, the incubation period for the onset of swelling, and the stationary swelling rate. It was found that the tube samples, characterized with austenite grain sizes of 9–12 µm before irradiation, have an average swelling rate of 0.035–0.05 %/dpa after reaching the maximum damaging doses of 66–77 dpa (at a rate of (1–1.5)×10 -6  dpa/s) and not more than 0.035%/dpa at doses less than 20 dpa (at a rate of 5×10 -7  dpa/s). The characteristic maximum swelling temperature of the studied material is in the range of 430–500 °C. The characteristic maximum swelling dose is in the range of 61–72.5 dpa or 70–80% of the maximum accumulated dose. The incubation stationary swelling period for the material is 30 dpa. The stationary swelling rate is 0.1% /dpa. The radiation resistance characteristics of the studied material have an advantage over those for 16Cr-15Ni grade cladding materials under similar irradiation conditions and a similar structural state, which inherits grain sizes of 9–14 μm during the tube processing.

16Cr-19Ni steel swelling at dose rates from 1×10 -8 to 1.6×10 -6 dpa/s