English (United Kingdom)

https://curated-unify.zendy.io/wp-json/zendy-region/v1/featured_content/oa?rat=en

https://curated-unify.zendy.io/wp-json/zendy-region/v1/highlighted_journal/

Global: Zendy Plus annual

Presents the access of premium content as premium feature

Premium Content

Presents the keyphrase highlighting as premium feature

Keyphrase Highlighting

Presents the summarisation as premium feature

Summarisation

Insights

Presents the pdf analysis as premium feature

PDF Analysis

Presents the zaia usage as premium feature

ZAIA

Global: Zendy Plus monthly

Global: Zendy Tools annual

Global: Zendy Tools monthly

Global: Zendy Free Plan

The swelling, corrosion and high-temperature embrittlement behavior of the fast-neutron sodium-cooled reactor standard and test fuel rod claddings was studied following the operation up to a damaging dose of 55 to 69 dpa. The tested characteristics were found to differ sensitively in conditions similar to irradiation for the claddings of the experimental tube conversion technology. Unlike the standard fuel rod claddings, the test rod claddings were additionally heated in the process of fabrication to homogenize the solid solution at different temperatures and austenitization times. On the whole, this led to an increased cladding resistance contrary the damaging factor of the reactor environment. The positive effect is explained by the influence of carbon and the morphology of swelling-reducing alloying elements, as well as by the nature of the carbide and intermetallide phase precipitation. However, the dispersion of the post-irradiation properties which remained significant and was also earlier observed in the standard rods is explained by potential differences in the heat treatment technology and the irradiation temperature in conditions of a hard-to-control coolant flow velocity. The swelling rate and the in-fuel corrosion depth for the test technology tubes were respectively 0.04 to 0.058%/dpa and 20 to 47 μm; similar values for the test material are 0.036 to 0.056%/dpa and 15 to 35 μm respectively. The short-term mechanical properties of the test fuel rods at a temperature of 600 °C showed a smaller tendency towards high-temperature embrittlement. The dispersion of the properties was caused by the chemical and structural heterogeneity as the result of the tube fabrication.

Analyzing the causes for the dispersion of the fast reactor spent fuel rod cladding properties *