English (United Kingdom)

https://curated-unify.zendy.io/wp-json/zendy-region/v1/featured_content/oa?rat=en

https://curated-unify.zendy.io/wp-json/zendy-region/v1/highlighted_journal/

Global: Zendy Plus annual

Presents the access of premium content as premium feature

Premium Content

Presents the keyphrase highlighting as premium feature

Keyphrase Highlighting

Presents the summarisation as premium feature

Summarisation

Insights

Presents the pdf analysis as premium feature

PDF Analysis

Presents the zaia usage as premium feature

ZAIA

Global: Zendy Tools annual

Global: Zendy Free Plan

Global: Zendy Tools monthly

Global: Zendy Plus monthly

The tribological behavior of various types of DLC coatings in formulated and non-formulated lubricants are needed for proper usage of these coatings. In this research, the friction and wear mechanism of four different DLC coatings in poly-alpha-olefin type 4 (PAO-4) with and without MoDTC were investigated using ball-on-disc tribometer. One ta-C (tetrahedral amorphous carbon) and three Cu/ta-C (copper doped ta-C) with different sputter power of 50 W, 150 W, and 200 W coatings were deposited on silicon wafers by using FCVA (filtered cathodic vacuum arc) technique for this research. The results indicate that ta-C coating on silicon wafer has the lowest average friction coefficient (CoF) and better wear resistance than Cu/ta-C coating when lubricated under PAO-4 oil with MoDTC. Cu/ta-C with sputter powers of 150 W and 200 W exhibited the highest average friction coefficient under PAO-4 oil with MoDTC. Meanwhile, the average CoF for all samples were similar under PAO-4 base oil. In terms of wear, ta-C coating showed the highest wear rate under PAO-4 base oil then followed by Cu/ta-C with sputter power of 50 W. Nonetheless, Cu/ta-C with sputter powers of 150 W and 200 W exhibited significantly low wear rate under PAO-4 base oil compared to PAO-4 oil with MoDTC.

Friction and Wear Mechanisms of Cu/ta-C Coatings Under PAO-4 and PAO-4 with MoDTC Lubrication