English (United Kingdom)

https://curated-unify.zendy.io/wp-json/zendy-region/v1/featured_content/oa?rat=en

https://curated-unify.zendy.io/wp-json/zendy-region/v1/highlighted_journal/

Global: Zendy Plus annual

Presents the access of premium content as premium feature

Premium Content

Presents the keyphrase highlighting as premium feature

Keyphrase Highlighting

Presents the summarisation as premium feature

Summarisation

Insights

Presents the pdf analysis as premium feature

PDF Analysis

Presents the zaia usage as premium feature

ZAIA

Global: Zendy Plus monthly

Global: Zendy Tools annual

Global: Zendy Tools monthly

Global: Zendy Free Plan

Galvanometer mirrors are used for optical applications such as target tracking, drawing, and scanning control because of their high speed and accuracy. However, the responsiveness of a galvanometer mirror is limited by its inertia; hence, the gain of a galvanometer mirror is reduced when the control path is steep. In this research, we propose a method to extend the corresponding frequency using a pre-emphasis technique to compensate for the gain reduction of galvanometer mirrors in sine-wave path tracking using proportional-integral-differential (PID) control. The pre-emphasis technique obtains an input value for a desired output value in advance. Applying this method to control the galvanometer mirror, the raw gain of a galvanometer mirror in each frequency and amplitude for sine-wave path tracking using a PID controller was calculated. Where PID control is not effective, maintaining a gain of 0 dB to improve the trajectory tracking accuracy, it is possible to expand the speed range in which a gain of 0 dB can be obtained without tuning the PID control parameters. However, if there is only one frequency, amplification is possible with a single pre-emphasis coefficient. Therefore, a sine wave is suitable for this technique, unlike triangular and sawtooth waves. Hence, we can adopt a pre-emphasis technique to configure the parameters in advance, and we need not prepare additional active control models and hardware. The parameters are updated immediately within the next cycle because of the open loop after the pre-emphasis coefficients are set. In other words, to regard the controller as a black box, we need to know only the input-to-output ratio, and detailed modeling is not required. This simplicity allows our system to be easily embedded in applications. Our method using the pre-emphasis technique for a motion-blur compensation system and the experiment conducted to evaluate the method are explained.

journal of visualized experiments

Gain-compensation Methodology for a Sinusoidal Scan of a Galvanometer Mirror in Proportional-Integral-Differential Control Using Pre-emphasis Techniques