English (United Kingdom)

https://curated-unify.zendy.io/wp-json/zendy-region/v1/featured_content/oa?rat=en

https://curated-unify.zendy.io/wp-json/zendy-region/v1/highlighted_journal/

Global: Zendy Plus annual

Presents the access of premium content as premium feature

Premium Content

Presents the keyphrase highlighting as premium feature

Keyphrase Highlighting

Presents the summarisation as premium feature

Summarisation

Insights

Presents the pdf analysis as premium feature

PDF Analysis

Presents the zaia usage as premium feature

ZAIA

Global: Zendy Tools annual

Global: Zendy Free Plan

Global: Zendy Tools monthly

Global: Zendy Plus monthly

The possibility of increasing the efficiency and expanding the technological capabilities of the process of deforming drawing, by studying the contact phenomena and force characteristics of the process of deforming drawing (flashing) with the imposition of ultrasonic vibrations on the tool.The main advantages of deforming drawing with application of ultrasound are noted, among which it is necessary to allocate considerable decrease in force parameters of process, reduction of level of residual stresses, increase of accuracy of the processed details. Also, the application of ultrasound allows you to process parts made of metal and alloys, the processing of which in normal conditions is impossible and requires special techniques. It is noted that it is not possible to use known designs of broaches and firmware when flashing with the application of ultrasonic vibrations, because the firmware must have all the dimensions related to the acoustic parameters and the deforming element must be placed on the mandrel with tension to create good acoustic contact between the mandrel and the element.Prefabricated deforming firmware for processing holes with the imposition of longitudinal ultrasonic vibrations has been developed and a method for calculating their deforming elements for strength has been proposed. The performed calculations showed that the calculated stresses differ from the allowable ones by no more than 15-20 %. From the above calculations it is seen that the deforming element can be destroyed, both under the action of the working load in the process of flashing, and under the action of thermal stresses after the exit of the element from the machined hole. This difference in the results of research can be explained by the fact that the order of tensile strength is a value that has a large scattering zone and in different studies it is different.The results of research on the strength of deforming elements can be used in engineering calculations in the design of prefabricated tools for drawing holes with ultrasound.

CALCULATION ON THE STRENGTH OF DEFORMING ELEMENTS AND DEVELOPMENT OF FIRMWARE STRUCTURES FOR ULTRASOUND PROCESSING