English (United Kingdom)

https://curated-unify.zendy.io/wp-json/zendy-region/v1/featured_content/oa?rat=en

https://curated-unify.zendy.io/wp-json/zendy-region/v1/highlighted_journal/

Global: Zendy Plus annual

Presents the access of premium content as premium feature

Premium Content

Presents the keyphrase highlighting as premium feature

Keyphrase Highlighting

Presents the summarisation as premium feature

Summarisation

Insights

Presents the pdf analysis as premium feature

PDF Analysis

Presents the zaia usage as premium feature

ZAIA

Global: Zendy Tools annual

Global: Zendy Free Plan

Global: Zendy Tools monthly

Global: Zendy Plus monthly

The hydraulic conductivity is known as the soil properties that mostly vary over an order of magnitude. There are many laboratory test methods to determine the hydraulic conductivity of the soil. Each test has its own merits, drawbacks and limitations. One of these methods is the measurement using a rigid wall permeameter (RWP), which is a common practice to obtain the fluid transmissibility characteristics of the soil matrix. This type of permeameter has the advantages of low cost, simplicity of test equipment, and adaptability to many different types of permeant liquids. Another method is the measurement through a flexible wall permeameter (FWP). The hydraulic conductivity measured using the FWP is conducted in a confined cylinder in which water flow is forced into one direction. The main disadvantage of this type is being relatively more expensive and needs more time to perform the test compared to the RWP. This study is aimed at comparing three testing conditions to obtain an adjustment factor for the hydraulic conductivity test normally carried out in practice in order to cut down the time needed to perform the test as well as its cost. Different mixtures of sand and expansive clay addition were considered to examine the effect of expansive clay content on the values of the hydraulic conductivity. Tests results revealed that the clay content had a significant effect on the swelling potential, which was attributed to structural changes in the mixtures. The hydraulic conductivity of mixtures decreases with the increase in clay content. The hydraulic conductivity of mixtures tested using FWP was observed to be lower than that of mixtures tested using RWP at similar clay contents. The tests conducted enabled establishing a correction factor to adjust the hydraulic conductivity normally obtained in practice using rigid wall cells.

Predicting Hydraulic Conductivity for Flexible Wall Conditions Using Rigid Wall Permeameter