English (United Kingdom)

https://curated-unify.zendy.io/wp-json/zendy-region/v1/featured_content/oa?rat=en

https://curated-unify.zendy.io/wp-json/zendy-region/v1/highlighted_journal/

Global: Zendy Plus annual

Presents the access of premium content as premium feature

Premium Content

Presents the keyphrase highlighting as premium feature

Keyphrase Highlighting

Presents the summarisation as premium feature

Summarisation

Insights

Presents the pdf analysis as premium feature

PDF Analysis

Presents the zaia usage as premium feature

ZAIA

Global: Zendy Tools annual

Global: Zendy Free Plan

Global: Zendy Tools monthly

Global: Zendy Plus monthly

This paper investigates the grinding process on unreinforced (PA66) and reinforced glass-fiber polyamide 6,6 (PA66 GF30) with Al 2 O 3 and SiC abrasive wheels. Both materials were ground by varying rotations, workpiece infeed speed, depth of cuts for sequential roughing/finishing steps. Dry and liquid coolant conditions were also considered during the grinding process to evaluate the effects on part quality. The surface roughness was used to assess the quality of the final products with several parameter combinations, identifying the induced process trends. The results show that at the end of the finishing step, the surface roughness R z  was lower than 4 μm, attaining the lowest value of 1.34 μm for PA66 specimens. The analysis also suggested the choice of the Al 2 O 3 grinding wheel to reach the lowest R z  values for both materials.

Evaluation of Grinding of Unfilled and Glass Fiber Reinforced Polyamide 6,6