English (United Kingdom)

https://curated-unify.zendy.io/wp-json/zendy-region/v1/featured_content/oa?rat=en

https://curated-unify.zendy.io/wp-json/zendy-region/v1/highlighted_journal/

Global: Zendy Tools annual

Presents the keyphrase highlighting as premium feature

Keyphrase Highlighting

Presents the summarisation as premium feature

Summarisation

Insights

Presents the pdf analysis as premium feature

PDF Analysis

Presents the zaia usage as premium feature

ZAIA

Global: Zendy Tools monthly

Global: Zendy Plus monthly

Presents the access of premium content as premium feature

Premium Content

Global: Zendy Plus annual

Global: Zendy Free Plan

Single-step trans-vertical moulds used to prepare grain mounts for SEM-automated-mineralogy based instruments have been shown to lead to more representative sample statistics. For samples that contain a variety of mineral phases, denser phases can settle to the bottom of an epoxy mould during the curing phase. Slicing and polishing a cross section through density-stratified moulds of the sample material can compensate for this. Aliquots from offshore drill well cuttings were prepared using three different methods: (1) traditional epoxy mounting, (2) two-step trans-vertical moulds, and (3) single-step trans-vertical moulds. All were analysed with a FEI Quanta 650 FEG instrument using MLA software with similar acquisition parameters. The results indicate that the single-step trans-vertical moulds are reproducible, lead to more accurate statistics, and yield MLA calculated elemental assays that closely match with data from standard analytical methods. In addition, these moulds can be made in half the time of the two-step trans-vertical moulds, and because of the unique geometry of the custom-made SEM holders, the analytical throughput is doubled. Depending on the size fraction of the well cuttings, the throughput can be further increased by slicing off the remaining epoxy to allow for more samples in the 26x TV holder. A unique cell holder was created to accommodate these trans-vertical samples, allowing them to fit into a LA-ICP-MS instrument such that detailed follow-up microanalyses can be conducted on specific minerals. For instance geochronology can be conducted on grains of interest (e.g., zircons), which had been mapped by the SEM-MLA.

High-Throughput Analysis of Offshore Well Drill-Cuttings via SEM-Automated Mineralogy Using Single-Step Trans-Vertical Moulds