English (United Kingdom)

https://curated-unify.zendy.io/wp-json/zendy-region/v1/featured_content/oa?rat=en

https://curated-unify.zendy.io/wp-json/zendy-region/v1/highlighted_journal/

Global: Zendy Plus annual

Presents the access of premium content as premium feature

Premium Content

Presents the keyphrase highlighting as premium feature

Keyphrase Highlighting

Presents the summarisation as premium feature

Summarisation

Insights

Presents the pdf analysis as premium feature

PDF Analysis

Presents the zaia usage as premium feature

ZAIA

Global: Zendy Tools annual

Global: Zendy Free Plan

Global: Zendy Tools monthly

Global: Zendy Plus monthly

The aim of this study is to evaluate the effect that the size of grinding media exerts on ferronickel slag milling efficiency and energy savings. A series of tests were performed in a laboratory ball mill using (i) three loads of single size media, i.e., 40, 25.4, and 12.7 mm and (ii) a mixed load of balls with varying sizes. In order to simulate the industrial ball milling operation, the feed to the mill consisted of slag with natural size distribution less than 850 μm. Grinding kinetic modeling and the attainable region (AR) approach were used as tools to evaluate the data obtained during the ball milling of slag. Particular importance was given to the determination of the specific surface area of the grinding products, the identification of the grinding limit, and the maximum specific surface area which could be achieved when different grinding media sizes were used. The results showed that, in general, the breakage rates of particles obey non-first-order kinetics and coarse particles are ground more efficiently than fines. The AR approach proved that there is an optimal grinding time (or specific energy input) dependent on the ball size used for which the volume fraction of the desired size class is maximized. The use of either 25.4 mm balls or a mixed load of balls with varying sizes results in 31 and 24% decrease in energy requirements, compared to the use of balls with small size (12.7 mm).

Effect of Grinding Media Size on Ferronickel Slag Ball Milling Efficiency and Energy Requirements Using Kinetics and Attainable Region Approaches