English (United Kingdom)

https://curated-unify.zendy.io/wp-json/zendy-region/v1/featured_content/oa?rat=en

https://curated-unify.zendy.io/wp-json/zendy-region/v1/highlighted_journal/

Global: Zendy Plus annual

Presents the access of premium content as premium feature

Premium Content

Presents the keyphrase highlighting as premium feature

Keyphrase Highlighting

Presents the summarisation as premium feature

Summarisation

Insights

Presents the pdf analysis as premium feature

PDF Analysis

Presents the zaia usage as premium feature

ZAIA

Global: Zendy Plus monthly

Global: Zendy Tools annual

Global: Zendy Tools monthly

Global: Zendy Free Plan

The as-welded sectors of China Fusion Engineering Testing Reactor (CFETR) vacuum vessel (VV) have very tight tolerances. However, it is difficult to investigate the welding stress and distortion without the production of a full-scale prototype. Therefore, it is important to predict and reduce the welding stress and distortion to guarantee the final assembly by using an accurately adjusted finite element model. In this paper, a full-scale finite element model of the 1/32 VV mock-up was built by ABAQUS which is a powerful finite element software for engineering simulation, and three different tungsten inert gas (TIG) welding sequences were simulated to study the effect of welding sequences on the welding stress and distortion. The results showed that the main welding stress happened on the weld zone, and the maximum distortion occurred on the shell near the welding joints between the inboard segment (PS1) and the lower segment (PS4). The inboard segment (PS1), upper segment (PS2), and lower segment (PS4) distorted to inside of the shell perpendicularly, while the equatorial segment (PS3) distorted to outside of the shell perpendicularly. According to the further analysis, the maximum welding stresses in sequence 1, sequence 2, and sequence 3 were 234.509 MPa, 234.731 MPa, and 234.508 MPa, respectively, and the average welding stresses were 117.268 MPa, 117.367 MPa, and 117.241 MPa, respectively, meanwhile, the maximum welding displacements in sequence 1, sequence 2, and sequence 3 were 1.158 mm, 1.157 mm, and 1.149 mm, respectively, and the average welding displacements were 1.048 mm, 1.053 mm, and 1.042 mm, respectively. Thus, an optimized welding sequence 3 was obtained and could be applied to the practical assembly process of the 1/32 VV mock-up.

metals

Analysis of the Effect of Tungsten Inert Gas Welding Sequences on Residual Stress and Distortion of CFETR Vacuum Vessel Using Finite Element Simulations