English (United Kingdom)

https://curated-unify.zendy.io/wp-json/zendy-region/v1/featured_content/oa?rat=en

https://curated-unify.zendy.io/wp-json/zendy-region/v1/highlighted_journal/

Global: Zendy Plus annual

Presents the access of premium content as premium feature

Premium Content

Presents the keyphrase highlighting as premium feature

Keyphrase Highlighting

Presents the summarisation as premium feature

Summarisation

Insights

Presents the pdf analysis as premium feature

PDF Analysis

Presents the zaia usage as premium feature

ZAIA

Global: Zendy Tools annual

Global: Zendy Free Plan

Global: Zendy Tools monthly

Global: Zendy Plus monthly

The paper studies the influence of 0.5–1.8 wt.% Ni alloying on the superplasticity, microstructural evolution, and dynamic grain growth effect in a temperature range of 625–775 °C and room temperature mechanical properties of two-phase Ti-Al-Mo-V alloys. Due to a decrease in β transus and an enhancement in the alloy diffusivity, an increase in Ni content significantly improved superplasticity. The Ni-modified alloys exhibited 1.5–3-fold lower flow stress, a 2.5–3-fold greater elongation to failure, and 1.4–1.7-fold higher strain rate sensitivity m coefficient compared to the Ni-free alloy. An intermetallic Ti2Ni compound precipitated in the 1.8 wt.% Ni-modified alloy during low-temperature deformation at 700 °C and decreased superplastic properties. The Ti-4Al-3Mo-1V-0.1B alloy with 0.9 wt.% Ni exhibited a good combination of the superplastic behavior and room-temperature mechanical properties: an elongation to failure of 500–900% at a low-temperature range of 625–775 °C and constant strain rate of 1 × 10−3 s−1 and a yield strength of 885 MPa and ultimate tensile strength of 1020 MPa after pre-straining for 100% in a superplastic regime and strengthening heat treatment.

Microstructure and Superplastic Behavior of Ni-Modified Ti-Al-Mo-V Alloys