English (United Kingdom)

https://curated-unify.zendy.io/wp-json/zendy-region/v1/featured_content/oa?rat=en

https://curated-unify.zendy.io/wp-json/zendy-region/v1/highlighted_journal/

Global: Zendy Plus annual

Presents the access of premium content as premium feature

Premium Content

Presents the keyphrase highlighting as premium feature

Keyphrase Highlighting

Presents the summarisation as premium feature

Summarisation

Insights

Presents the pdf analysis as premium feature

PDF Analysis

Presents the zaia usage as premium feature

ZAIA

Global: Zendy Plus monthly

Global: Zendy Tools annual

Global: Zendy Tools monthly

Global: Zendy Free Plan

The quantitative concentration of alloying elements in low-alloyed copper alloys is an important factor in forming electrical and mechanical characteristics. It is known that severe plastic deformation is accompanied by both a substantial refinement of the structure and changes in the kinetics of phase transformations during the deformation and the post-deformation thermal treatment. This paper presents the results of a comparative analysis of the Cu–0.2Cr and Cu–1.1Cr alloys subjected to equal-channel angular pressing at room temperature. The analysis was performed for the grain structure, solid solution, and second-phase particles using transmission electron microscopy, scanning electron microscopy, X-ray crystal analysis, and the small-angle diffraction method. It was found that the level of structure refinement and mechanical characteristics after equal-channel angular pressing was almost the same for both studied alloys. Post-deformation aging of the Cu–0.2Cr alloy leads to the development of polygonization and re-crystallization within it. The aging of the Cu–1.1Cr alloy shows a better thermal stability than that of the Cu–0.2Cr alloy. In the Cu–1.1Cr alloy, after aging, in comparison with Cu–0.2Cr, a denser-packed ensemble of fine particles with an average size of 54 ± 2 nm is formed. In this case, the average size of fragments is 270 ± 15 nm and the ultimate tensile strength reaches 485 MPa.

metals

Influence of the Chromium Content in Low-Alloyed Cu–Cr Alloys on the Structural Changes, Phase Transformations and Properties in Equal-Channel Angular Pressing