English (United Kingdom)

https://curated-unify.zendy.io/wp-json/zendy-region/v1/featured_content/oa?rat=en

https://curated-unify.zendy.io/wp-json/zendy-region/v1/highlighted_journal/

Global: Zendy Plus annual

Presents the access of premium content as premium feature

Premium Content

Presents the keyphrase highlighting as premium feature

Keyphrase Highlighting

Presents the summarisation as premium feature

Summarisation

Insights

Presents the pdf analysis as premium feature

PDF Analysis

Presents the zaia usage as premium feature

ZAIA

Global: Zendy Tools annual

Global: Zendy Free Plan

Global: Zendy Tools monthly

Global: Zendy Plus monthly

This paper presents experimental data on the microstructure and martensite transformation temperatures of Ti49.8Ni50.2 (at%) after abc pressing (multi-axial forging) to different true strains e from 1.84 to 9.55 at 573 K. The data show that increasing the true strain results in grain–subgrain refinement on different scales at a time. With e = 9.55 at 573 K, the average grain–subgrain size measured approximately 130 nm. Decreasing the abc pressing temperature from 723 to 573 K caused a decrease in all martensite transformation temperatures, a change in the lattice parameters, R phase formation, and angular shifts of diffraction peaks and their broadening. The largest change in the microstructure of Ti49.8Ni50.2 was provided by abc pressing to e = 1.84. Increasing the true strain to e = 9.55 resulted in a much smaller effect, suggesting that the alloy obtained a high density of structural defects even at e = 1.84. Two possible mechanisms of grain–subgrain refinement are discussed.

Effect of abc Pressing at 573 K on the Microstructure and Martensite Transformation Temperatures in Ti49.8Ni50.2 (at%)