English (United Kingdom)

https://curated-unify.zendy.io/wp-json/zendy-region/v1/featured_content/oa?rat=en

https://curated-unify.zendy.io/wp-json/zendy-region/v1/highlighted_journal/

Global: Zendy Plus annual

Presents the access of premium content as premium feature

Premium Content

Presents the keyphrase highlighting as premium feature

Keyphrase Highlighting

Presents the summarisation as premium feature

Summarisation

Insights

Presents the pdf analysis as premium feature

PDF Analysis

Presents the zaia usage as premium feature

ZAIA

Global: Zendy Plus monthly

Global: Zendy Tools annual

Global: Zendy Tools monthly

Global: Zendy Free Plan

In this research, we investigated the influence of the sintering temperature on the physical and mechanical properties of micro-sized bi-material components of 17-4PH stainless steel and 3 mol% yttria-stabilized zirconia fabricated using a two-component micro-powder injection molding (2C-μPIM) process. First, 17-4PH and zirconia powders were separately mixed with binders to obtain feedstocks, which were then injection-molded into the dumbbell shape, followed by the binder extraction process. Subsequently, the debound micro-specimens were subjected to sintering between 1250 °C and 1350 °C for 3 h. Per the observations of the microstructures using scanning electron microscopy (SEM), a strong bond between metal and ceramic in micro-sized 17-4PH/zirconia components was formed when the sintering temperature exceeded 1300 °C. The maximum relative density of 99% was achieved when the bi-material micro-part was sintered at 1350 °C. The linear shrinkage increased from 9.6% to 17.4% when the sintering temperature was increased from 1250 °C to 1350 °C. The highest hardness value of 1439.6 HV was achieved at 1350 °C along the bi-material bonding region. Moreover, a maximum tensile strength of 13.7 MPa was obtained at 1350 °C.

materials

Sintering Behavior of Bi-Material Micro-Component of 17-4PH Stainless Steel and Yttria-Stabilized Zirconia Produced by Two-Component Micro-Powder Injection Molding Process