English (United Kingdom)

https://curated-unify.zendy.io/wp-json/zendy-region/v1/featured_content/oa?rat=en

https://curated-unify.zendy.io/wp-json/zendy-region/v1/highlighted_journal/

Global: Zendy Plus annual

Presents the access of premium content as premium feature

Premium Content

Presents the keyphrase highlighting as premium feature

Keyphrase Highlighting

Presents the summarisation as premium feature

Summarisation

Insights

Presents the pdf analysis as premium feature

PDF Analysis

Presents the zaia usage as premium feature

ZAIA

Global: Zendy Tools annual

Global: Zendy Free Plan

Global: Zendy Tools monthly

Global: Zendy Plus monthly

This study investigated the fatigue life of welded joints, in particular, the welds of the high-strength steel S960 QL. The welds were created using unconventional technologies by utilising laser and electron beams. The direct application of the research is intended to be carried out through implementing the results towards the design of tracks for the track-wheel chassis of the demining system Božena 5. The producer's experience shows the damage found in the current track design. The damage occurred during reversing the vehicle on a sand surface. Our goal was to solve this problem. The information acquired in this research will be a very important input factor for further designs of the track made of the tested material and its welds. The analysis of the residual stresses was also part of this study. The experimental research of the tested material's fatigue life and welded joints was realised on the specimens loaded using cyclic bending and cyclic torsion. These loads were dominant during the track operation. The fatigue life of the tested material was detected using a device designed by us. The measurement results were processed in the form of the Wöhler's S-N curves (alternating stress versus number cycles to failure) and compared with the current regulations issued by the International Institute of Welding (IIW) in the form of the FAT curves (IIW fatigue class). The achieved research results indicate that the modern welding technologies (laser and electron beams) used on the high-strength steel had no principal influence on the fatigue life of the tested material.

Research of the Fatigue Life of Welded Joints of High Strength Steel S960 QL Created Using Laser and Electron Beams