English (United Kingdom)

https://curated-unify.zendy.io/wp-json/zendy-region/v1/featured_content/oa?rat=en

https://curated-unify.zendy.io/wp-json/zendy-region/v1/highlighted_journal/

Global: Zendy Plus annual

Presents the access of premium content as premium feature

Premium Content

Presents the keyphrase highlighting as premium feature

Keyphrase Highlighting

Presents the summarisation as premium feature

Summarisation

Insights

Presents the pdf analysis as premium feature

PDF Analysis

Presents the zaia usage as premium feature

ZAIA

Global: Zendy Tools annual

Global: Zendy Free Plan

Global: Zendy Tools monthly

Global: Zendy Plus monthly

There is difficulty in accurately modelling adhesive influence in structural performance of cross laminated timber (CLT), due to a lack of available knowledge on the heat performance of adhesives. Therefore, the main aim of this research was to evaluate the thermal and mechanical properties of adhesives used in production of engineered wood products like CLT. The properties of the timber species and the adhesive types used in the simulation were derived from published literature and handbooks. ANSYS mechanical 2020 R1 was employed because it has a provision for inserting the thermal condition and the temperature of the system set to the required one for analysis. The simulations were conducted for temperatures 20, 100, 140, 180, 220 and 260 oC, within which Zelinka et al conducted their experiments, which have been the basis for the current study. The main findings were, the adhesive layer had little influence on the thermal properties of CLT composite (solid wood had the same thermal properties as CLT), but had a significant effect on the structural properties of CLT composite, the stresses and strains of the simulated wood species reduced with increase in temperature, the adhesives strengths at room temperature were greater than for solid wood at the same temperature and finally, the stresses and strains of the simulated wood adhesives reduced with increase in temperature. It is also important to note that computations for temperature distribution from the char layer were lower than computed using heat transfer equation, and the simulated values from steady state model. All in all, the objectives of this research were met and more research in thermal structural modelling using ANSYS should be conducted in the future.

Modelling of Elevated Temperature Performance of Adhesives Used in Cross Laminated Timber: An Application of ANSYS Mechanical 2020 R1 Structural Analysis Software