English (United Kingdom)

https://curated-unify.zendy.io/wp-json/zendy-region/v1/featured_content/oa?rat=en

https://curated-unify.zendy.io/wp-json/zendy-region/v1/highlighted_journal/

Global: Zendy Plus annual

Presents the access of premium content as premium feature

Premium Content

Presents the keyphrase highlighting as premium feature

Keyphrase Highlighting

Presents the summarisation as premium feature

Summarisation

Insights

Presents the pdf analysis as premium feature

PDF Analysis

Presents the zaia usage as premium feature

ZAIA

Global: Zendy Tools annual

Global: Zendy Free Plan

Global: Zendy Tools monthly

Global: Zendy Plus monthly

In this paper, we investigate implications of running a cooling system of two silicagel/water adsorption chillers powered by a district heating network. The devices are connected in series, i.e., the heating water output from the primary chiller is directed to the secondary one. In consequence, the secondary device must deal with an even lower driving temperature and with temperature fluctuations caused by the primary device. We have evaluated three factors that influence the operation of those coupled devices: synchronization of their operating cycles, selection of their cycle time allocations (CTAs), and changing the heating water mass flow rate. Numerical analyses indicate that the performance of the secondary chiller drops significantly if the coupled devices that use the same CTA run asynchronously. The decrease is largest if the shift between the operating cycles is x=0.375 and x=0.875. We found that it is possible to reduce the negative influence of the asynchronous operation by implementing different CTA in each chiller. The best performance is achieved if the primary chiller uses an adsorption time to desorption time ratio f=1.0 and the secondary chiller uses f = 0.6–0.7.

Recommendations for Running a Tandem of Adsorption Chillers Connected in Series and Powered by Low-Temperature Heat from District Heating Network