English (United Kingdom)

https://curated-unify.zendy.io/wp-json/zendy-region/v1/featured_content/oa?rat=en

https://curated-unify.zendy.io/wp-json/zendy-region/v1/highlighted_journal/

Global: Zendy Plus annual

Presents the access of premium content as premium feature

Premium Content

Presents the keyphrase highlighting as premium feature

Keyphrase Highlighting

Presents the summarisation as premium feature

Summarisation

Insights

Presents the pdf analysis as premium feature

PDF Analysis

Presents the zaia usage as premium feature

ZAIA

Global: Zendy Tools annual

Global: Zendy Free Plan

Global: Zendy Tools monthly

Global: Zendy Plus monthly

Al2O3 coatings were applied on the surface of 12Ch18N10T steel by the detonation method at different degrees of filling of the detonation gun. The aim was to study the influence of technological parameters on the formation of the coating’s structure, phase composition and tribological characteristics. The degree of filling the gun with a gas mixture (C2H2/O2) varied from 53% to 68%. X-ray diffraction study showed that the content of α-Al2O3 increases depending on the degree of filling. The results showed that the hardness increases with an increase in the α-Al2O3 phase. When the gun is 53% filled with gas, the Al2O3-based coating has the hardness of 20.56 GPa compared to 58%, 63% and 68% fillings. Tribology tests have shown that the wear rate and friction coefficient of the coating is highly dependent on the degree of filling of the gun.

Influence of Detonation-Spraying Parameters on the Phase Composition and Tribological Properties of Al2O3 Coatings