English (United Kingdom)

https://curated-unify.zendy.io/wp-json/zendy-region/v1/featured_content/oa?rat=en

https://curated-unify.zendy.io/wp-json/zendy-region/v1/highlighted_journal/

Global: Zendy Plus annual

Presents the access of premium content as premium feature

Premium Content

Presents the keyphrase highlighting as premium feature

Keyphrase Highlighting

Presents the summarisation as premium feature

Summarisation

Insights

Presents the pdf analysis as premium feature

PDF Analysis

Presents the zaia usage as premium feature

ZAIA

Global: Zendy Tools annual

Global: Zendy Free Plan

Global: Zendy Tools monthly

Global: Zendy Plus monthly

It is important to systematically investigate the similar materials with high similarity ratio and low strength in multilayer shale deposits, to provide a scientific basis and experimental basis for the research of underground mining of multilayer shale deposits. In this paper, using an orthogonal experimental method, the physical and mechanical parameters of different material proportions were analyzed with four control factors of mica powder/standard sand, filling material/bonding material, Portland cement/gypsum, silicone oil ratio. Twenty-five groups of material proportioning schemes were designed, and the density, porosity, compressive strength, and elastic modulus of each group of materials were measured. Through the range analysis and significance analysis, the influence of control factors on the material parameters was explored, and multivariate linear regression analysis of test results was carried to eliminate outliers. The result showed that the physical and mechanical parameters of similar materials prepared according to the proportioning scheme were widely distributed, which can meet the preparation requirements of similar materials with different lithologies. The density and compressive strength were most affected by the ratio of Portland cement/gypsum, the porosity was most affected by the ratio of filling material/bonding material, and the elastic modulus was mainly controlled by the silicone oil ratio. The proportioning scheme was applied to three similar prepared shale materials with large lithology differences. The error between actual similar constant and design similar constant of low strength similar material was less than 1.62%. The physical and mechanical parameters of similar materials were in good agreement with the original rock.

Experiments on Material Proportions for Similar Materials with High Similarity Ratio and Low Strength in Multilayer Shale Deposits