English (United Kingdom)

https://curated-unify.zendy.io/wp-json/zendy-region/v1/featured_content/oa?rat=en

https://curated-unify.zendy.io/wp-json/zendy-region/v1/highlighted_journal/

Global: Zendy Plus annual

Presents the access of premium content as premium feature

Premium Content

Presents the keyphrase highlighting as premium feature

Keyphrase Highlighting

Presents the summarisation as premium feature

Summarisation

Insights

Presents the pdf analysis as premium feature

PDF Analysis

Presents the zaia usage as premium feature

ZAIA

Global: Zendy Tools annual

Global: Zendy Free Plan

Global: Zendy Tools monthly

Global: Zendy Plus monthly

The increasing demand for single-crystal wafers combined with the increase in diameter of semiconductor wafers has warranted further improvements in thickness variation and material removal rate during lapping to ensure price competitiveness of wafers; consequently, the lapping process has gained the attention of researchers. However, there is insufficient research on the effect of platen grooves on the lapping process. In this study, the parameters to describe grooves were defined in order to understand their influence on the lapping process, and a material removal model was suggested based on indentation theory and subsequently experimentally validated. The results indicate that changes in groove density affect the lubrication condition at the contact interface as well as the probability of abrasive participation by varying the oil film thickness. When fabricating the groove for a lapping platen, a groove density at the critical groove density (CGD) or higher should be selected. The higher the groove density, the easier it is to avoid the CGD, and the higher is the material removal rate. The results of this study will enable engineers to design lapping platen grooves that are suitable for the production of modern semiconductor wafers.

Material Removal Model for Lapping Process Based on Spiral Groove Density