English (United Kingdom)

https://curated-unify.zendy.io/wp-json/zendy-region/v1/featured_content/oa?rat=en

https://curated-unify.zendy.io/wp-json/zendy-region/v1/highlighted_journal/

Global: Zendy Plus annual

Presents the access of premium content as premium feature

Premium Content

Presents the keyphrase highlighting as premium feature

Keyphrase Highlighting

Presents the summarisation as premium feature

Summarisation

Insights

Presents the pdf analysis as premium feature

PDF Analysis

Presents the zaia usage as premium feature

ZAIA

Global: Zendy Tools annual

Global: Zendy Free Plan

Global: Zendy Tools monthly

Global: Zendy Plus monthly

This study investigated the effect of the electromagnetic stirring (EMS) process on the microstructure and mechanical properties of hyper-eutectic Al-15 wt.%Si alloy. The tensile and high-cycle fatigue properties of the EMS Al-15wt.%Si alloy were examined and compared with conventional direct chill (DC) cast alloy. The initial microstructure of the as-cast DC alloy showed a coarse primary Si of 70 µm, in contrast to the size (40 µm) of the as-cast EMS alloy. The DC extruded alloy exhibited a massive primary Si size of 40~55 µm. In contrast, the EMS extruded alloy had a spherical primary Si with 30~40 µm sizes. The average grain sizes were measured to be 8.8 µm (EMS extruded alloy) and 11.4 µm (DC extruded alloy), respectively. The EMS process was confirmed to contribute to the refinement of the grain size and the primary Si size of the hyper-eutectic Al-Si alloy. The yield strengths at room temperature were measured to be 388.0 MPa (EMS extruded alloy) and 375.0 MPa (DC extruded alloy), and the tensile strengths were 426.0 MPa (EMS extruded alloy) and 412.4MPa (DC extruded alloy), respectively. The elongations of both alloys were similar at room temperature. The fatigue limit of the EMS extruded alloy (130 MPa) was higher than that of the DC extruded alloy (120 MPa). The EMS extruded alloy exhibited superior fatigue resistance compared to the DC extruded alloy, regardless of the cyclic stress condition. This study also discussed the potential value of the EMS process as a method for improving the properties of hyper-eutectic Al-Si alloy, as well as the deformation and fracture mechanisms of the EMS Al-15wt.%Si alloy.

Effect of EMS Process on the Primary Si Refinement, Tensile and Fatigue Properties of Hyper-eutectic Al-15wt.%Si Alloy