English (United Kingdom)

https://curated-unify.zendy.io/wp-json/zendy-region/v1/featured_content/oa?rat=en

https://curated-unify.zendy.io/wp-json/zendy-region/v1/highlighted_journal/

Global: Zendy Plus annual

Presents the access of premium content as premium feature

Premium Content

Presents the keyphrase highlighting as premium feature

Keyphrase Highlighting

Presents the summarisation as premium feature

Summarisation

Insights

Presents the pdf analysis as premium feature

PDF Analysis

Presents the zaia usage as premium feature

ZAIA

Global: Zendy Tools annual

Global: Zendy Free Plan

Global: Zendy Tools monthly

Global: Zendy Plus monthly

Real time paper surface-web measurement is one of the challenging research fields. The traditional laboratory method has many limitations and is unable to measure the entire tambour during the manufacturing process. It has been necessary to develop an online technique that could measure the surface topography in real time. An optical technique was developed, based on laser triangulation, and is applied to develop a new prototype device, which characterizes high speed paper-web surfaces over a wide scale of spatial wavelengths spectrum and computes the surface roughness in real time. The used multi channel pulsed laser diode, source of illumination onto the paper-web, is of benefit due to its low coherence length and is capable to deliver a powerful burst of light beam over a 1 µs duration, which delivers energy of 100 µJ per pulse. The short exposure time avoids blurriness in the acquired images which could possible due to the high speed and vibrations on the paper-web.The laser beam is shaped into a narrow line-of-light using cylindrical lenses and is projected onto a paper-web surface, which covers a physical length of about 210 mm. The created line-of-light cross section full width at half maximum, FWHM Gaussian distribution, is 2-3 pixels on the image. The line-of-light is projected onto the paper-web perpendicular to the plane of the surface. The low angled, low specular, reduced coherence length, scattered reflected laser line is captured by the 3 CCD sensors, which are synchronized with the laser source. The low specular light ensures to avoid saturation of the imaging sensors if the surface is very smooth, and obliquely captures the z-directional fine feature of the surface.The scattered phenomenon of the reflected light is responsible for the surface irregularity measurements. The basic image processing algorithm is applied in order to remove noise and cropped the images widthwise so that only pixels above a preset threshold gray level can be processed, which enables efficient real time measurement. The image is transformed into a 1D array using the center of gravity, COG. The accuracy and precision of the COG depends on the line-of-light FWHM, which, in turn, is responsible for the accuracy, noise and the resolution of the developed technique. The image subpixel resolution achieved is 0.01 times a pixel and uuncertainty in the raw data is 0.43 µm while it is 0.05 µm in the rms roughness.The signal processing steps combining the B-Spline filter and the filter in the spatial frequency domain were employed in order to separate roughness, waviness, and form and position error in the raw profile. The prototype is designed to measure online surface roughness and to characterize surface in a spatial wavelength spectrum from 0.09 to 30 mm, which is extendable to any required spatial range in order to cover a wide scale surface feature such as micro roughness, macro roughness and waviness. It is proven that exploitation of a simple laser triangulation technique could lead to an improvement in the overall quality and efficiency in the paper and paperboard industries and it can also be of potential interest for the other surface characterization problems.

nordic pulp and paper research journal

MECHANICAL PULPING: Investigation of the surface topographical differences between the Cross Direction and the Machine Direction for newspaper and paperboard