English (United Kingdom)

https://curated-unify.zendy.io/wp-json/zendy-region/v1/featured_content/oa?rat=en

https://curated-unify.zendy.io/wp-json/zendy-region/v1/highlighted_journal/

Zendy Open

Presents the pdf analysis as premium feature

PDF Analysis

Insights

Presents the summarisation as premium feature

Summarisation

Presents the keyphrase highlighting as premium feature

Keyphrase Highlighting

Presents the zaia usage as premium feature

ZAIA

Zendy Tools

Zendy Plus

Presents the access of premium content as premium feature

Premium Content

The die in the melt spinning process distributes the whole melt stream into individual small melt streams that pass the die parallel to each other. The number of holes in the die determines the number of filaments in the spun fiber bundle. As the whole melt stream (i. e. the total throughput) is enforced by a precise gear pump (the spinning pump) the sharing out into the single hole throughputs is dependent on the pressure and the flow resistances of the single holes. Only for constant pressure and equal resistances the single hole throughputs are equal, too. The present paper deals with the influence of geometrical inaccuracies of the holes in the spinning die on the fineness and structural variations across the spun fiber bundle.

Manufacture-Induced Inaccuracies of Spinning Dies 1: Do They Influence the Fineness and Structural Unevennesses of PA 6 and PET Multifilament Yarns?