English (United Kingdom)

https://curated-unify.zendy.io/wp-json/zendy-region/v1/featured_content/oa?rat=en

https://curated-unify.zendy.io/wp-json/zendy-region/v1/highlighted_journal/

Global: Zendy Plus annual

Presents the access of premium content as premium feature

Premium Content

Presents the keyphrase highlighting as premium feature

Keyphrase Highlighting

Presents the summarisation as premium feature

Summarisation

Insights

Presents the pdf analysis as premium feature

PDF Analysis

Presents the zaia usage as premium feature

ZAIA

Global: Zendy Tools annual

Global: Zendy Free Plan

Global: Zendy Tools monthly

Global: Zendy Plus monthly

The phenomenon of shrinkage in injection moulding is particularly evident in semi-crystalline polymers. During cooling, these materials experience a transition from a completely amorphous to a partially crystalline status, which results in a severe change of all material characteristics, including volumetric parameters. In this study an iPP was injection moulded in a rectangular impression (120 mm × 30 mm × 2 mm) with a 1.5 mm thick line gate. The influence of holding pressure and time, and geometry constraints on linear shrinkage was explored. In-mould shrinkage was measured by means of a recent method based on strain gauges. Experimental results are compared with predictions for shrinkage obtained by C-Mold and a code developed at the University of Salerno, which takes into account crystallisation kinetics. The solidification criterion resulted to be extremely relevant for shrinkage predictions.

Solidification Criterion on Shrinkage Predictions for Semi-crystalline Injection Moulded Samples