English (United Kingdom)

https://curated-unify.zendy.io/wp-json/zendy-region/v1/featured_content/oa?rat=en

https://curated-unify.zendy.io/wp-json/zendy-region/v1/highlighted_journal/

Zendy Open

Presents the pdf analysis as premium feature

PDF Analysis

Insights

Presents the summarisation as premium feature

Summarisation

Presents the keyphrase highlighting as premium feature

Keyphrase Highlighting

Presents the zaia usage as premium feature

ZAIA

Zendy Tools

Zendy Plus

Presents the access of premium content as premium feature

Premium Content

The superplastic behavior of Ti-13V-11Cr-3Al alloy with beta single phase structure and average grain size of 220 μm was investigated. It was found that elongation increases with temperature at strain rates of 0.1 and 1 s −1 . The optimum condition for superplastic deformation of the alloy was achieved in the temperature range 1030–1080°C and with a strain rate of 0.1 s −1 . In this condition the amount of elongation reaches 200%. Grain refinement occurred during deformation which can be attributed to the occurrence of dynamic recovery and continuous dynamic recrystallization. In addition, it was seen that in the temperature range 930–1080°C, the strain rate sensitivity parameter ( m ) was higher than 0.3, which is an appropriate value for superplastic deformation. A high value of  m , elongation over 100%, and coarse-grained microstructure of the alloy suggested that superplastic behavior of the Ti-13V-11Cr-3Al alloy can be similar to the behavior of coarse-grained superplastic alloys.

Superplasticity of coarse-grained Ti-13V-11Cr-3Al alloy