English (United Kingdom)

https://curated-unify.zendy.io/wp-json/zendy-region/v1/featured_content/oa?rat=en

https://curated-unify.zendy.io/wp-json/zendy-region/v1/highlighted_journal/

Zendy Open

Presents the pdf analysis as premium feature

PDF Analysis

Insights

Presents the summarisation as premium feature

Summarisation

Presents the keyphrase highlighting as premium feature

Keyphrase Highlighting

Presents the zaia usage as premium feature

ZAIA

Zendy Tools

Zendy Plus

Presents the access of premium content as premium feature

Premium Content

In this study, the weldability of lower strength St 37 grade steel plate with a higher strength steel plate (i. e., St 44) using the friction stir welding technique has been studied. St 37 grade steel sheets are widely used in various industries. However, the joining of St 37 steel plates with higher strength grades such as St 44 grade steel is usually required when the strength of St 37 grade is not sufficient. Therefore, microstructural and mechanical properties of friction stir welded St 37-St 44 butt joints were investigated by conducting optical microscopy, microhardness measurements, and tensile testing. A fine-grained recrystallized microstructure was observed in the weld regions of the joints produced. The highest tensile strength, i. e. 385 MPa, was exhibited by the joint produced at 630 rev × min −1 .

Mechanical properties of friction stir welded St 37 and St 44 steel joints