English (United Kingdom)

https://curated-unify.zendy.io/wp-json/zendy-region/v1/featured_content/oa?rat=en

https://curated-unify.zendy.io/wp-json/zendy-region/v1/highlighted_journal/

Zendy Open

Presents the pdf analysis as premium feature

PDF Analysis

Insights

Presents the summarisation as premium feature

Summarisation

Presents the keyphrase highlighting as premium feature

Keyphrase Highlighting

Presents the zaia usage as premium feature

ZAIA

Zendy Tools

Zendy Plus

Presents the access of premium content as premium feature

Premium Content

AlN plates were fabricated by hot pressing AlN-Y 2 O 3  and AlN-Y 2 O 3 -Al 2 O 3  powder mixtures at 1700–1900 °C using yttria and alumina (Al 2 O 3  particle sizes of 3 and 10 μm) powders as sintering additives. The physical and mechanical properties of the hot-pressed AlN ceramics were characterized using X-ray diffraction (XRD), scanning electron microscopy (SEM) and energy-dispersive X-ray spectroscopy (EDS). The density, thermal conductivity, transverse rupture strength, and grain size were measured. The thermal conductivity of the hot–pressed AlN ceramics ranged between 83–92.7 W × (m × K) −1  and decreased with the addition of Al 2 O 3 , whereas the mechanical properties improved with the addition of Al 2 O 3 , which is known to have a beneficial effect of grain size refinement. The measured density values of 3.31 to 3.34 g × cm −3  were slightly higher than the theoretical density of 3.26 g × cm −3 . This result was attributed to the use of a carbon mold under N 2  atmosphere, which effectively removed oxygen atoms from the yttrium-aluminate phase that is expected to form at 1100 °C.

Effects of Y 2 O 3 and Al 2 O 3 sintering additives on the hot pressing behavior of AlN ceramics