English (United Kingdom)

https://curated-unify.zendy.io/wp-json/zendy-region/v1/featured_content/oa?rat=en

https://curated-unify.zendy.io/wp-json/zendy-region/v1/highlighted_journal/

Zendy Plus

Presents the access of premium content as premium feature

Premium Content

Presents the keyphrase highlighting as premium feature

Keyphrase Highlighting

Presents the summarisation as premium feature

Summarisation

Insights

Presents the pdf analysis as premium feature

PDF Analysis

Presents the zaia usage as premium feature

ZAIA

Zendy Tools

Zendy Open

The part fabricated by fused deposition modeling (FDM) process is influenced by fabrication parameters viz., layer resolution, processing quality, fill mode and the processing material on surface roughness. In this work, effects of fabrication parameters are investigated experimentally. The test specimen is designed and the levels of various factor are setup respectively. Then Taguchi's parameter design is applied to find the optimum factor levels for top surface roughness and sides surface roughness. The evaluation of surface roughness is expressed as signal-to-noise (S/N) ratio . Finally the main effect plot for S/N ratio is obtained and the optimum factor levels for top surface roughness and sides surface roughness respectively are found from analysis of experimental results. Keywords—fused deposition modeling; surface roughness; taguchi's parameter design; main effect plot

Effect of Fabrication Parameters and Material Features on Surface Roughness of FDM Build Parts