English (United Kingdom)

https://curated-unify.zendy.io/wp-json/zendy-region/v1/featured_content/oa?rat=en

https://curated-unify.zendy.io/wp-json/zendy-region/v1/highlighted_journal/

Global: Zendy Plus annual

Presents the access of premium content as premium feature

Premium Content

Presents the keyphrase highlighting as premium feature

Keyphrase Highlighting

Presents the summarisation as premium feature

Summarisation

Insights

Presents the pdf analysis as premium feature

PDF Analysis

Presents the zaia usage as premium feature

ZAIA

Global: Zendy Plus monthly

Global: Zendy Tools annual

Global: Zendy Tools monthly

Global: Zendy Free Plan

The aim of this study was to develop a deposition process using RF magnetron sputtering for the production of zinc oxide (ZnO) thin films on glass substrates. These ZnO films were to be used as the active piezoelectric element in very high frequency ultrasound transducers (&gt; 300 MHz). In order to achieve piezoelectric activity the films had to be oriented with the c-axis of the ZnO grains perpendicular to the substrate surface. At the same time, a moderately high, at least 1 m=hr (17 nm=min) deposition rate was required for the production of practical devices. Prior to a full investigation into the sputtering parameters, an initial evaluation of the HHV Auto500 RF magnetron sputter coater system was performed. Using the original chamber configuration it was not possible to deposit ZnO at the required deposition rates. A modification of the growth chamber to allow a reduced target-substrate distance was successful in producing ZnO films at the required deposition rates. A systematic study into the deposition parameters and their effect on the ZnO film quality and deposition rates was then performed and it was found that strong c-axis oriented films could be deposited only when depositing at rates below 15 nm=min at a low substrate temperature (

Microstructural control of ZnO films deposited by RF magnetron sputtering for ultrasound transducers