English (United Kingdom)

https://curated-unify.zendy.io/wp-json/zendy-region/v1/featured_content/oa?rat=en

https://curated-unify.zendy.io/wp-json/zendy-region/v1/highlighted_journal/

Global: Zendy Plus annual

Presents the access of premium content as premium feature

Premium Content

Presents the keyphrase highlighting as premium feature

Keyphrase Highlighting

Presents the summarisation as premium feature

Summarisation

Insights

Presents the pdf analysis as premium feature

PDF Analysis

Presents the zaia usage as premium feature

ZAIA

Global: Zendy Tools annual

Global: Zendy Free Plan

Global: Zendy Tools monthly

Global: Zendy Plus monthly

The aim of the research was to define and develop a wooden composite with a thin cross-section and which could be used as reinforcement material in oversized wooden window profiles. An additional limitation was to bond the composite at room temperature. Based on a review of the literature, laminated veneer lumber (LVL) was chosen as the best option. The researched LVL samples were made of 0.5 mm thick, cut, beech (Fagus sylvatica L.) veneer, bonded with polyurethane adhesive (Purbond HB 440). Half of the samples were made of thermally modified veneers, and other half of unmodified. Bending strength and stiffness were determined with a three-point bending test. Thermally modified samples had on average 19 % lower bending strength compared to the unmodified samples, but the modulus of elasticity (stiffness) did not change significantly. The bending strength of up to 150 MPa was satisfactory, but the modulus of elasticity of 13 GPa was far below expectations. This is attributed to the selection of too thin veneer and too low bonding temperature, which does not enable densification of the composite.

Upogibna trdnost in togost slojnatega furnirnega lesa (LVL) iz termično modificirane in nemodificirane bukovine