English (United Kingdom)

https://curated-unify.zendy.io/wp-json/zendy-region/v1/featured_content/oa?rat=en

https://curated-unify.zendy.io/wp-json/zendy-region/v1/highlighted_journal/

Global: Zendy Tools annual

Presents the keyphrase highlighting as premium feature

Keyphrase Highlighting

Presents the summarisation as premium feature

Summarisation

Insights

Presents the pdf analysis as premium feature

PDF Analysis

Presents the zaia usage as premium feature

ZAIA

Global: Zendy Tools monthly

Global: Zendy Plus monthly

Presents the access of premium content as premium feature

Premium Content

Global: Zendy Plus annual

Global: Zendy Free Plan

A mud pump is a reciprocating liner (piston/plunger) pump designed to circulate drilling fluid under high pressure down the drill string and back up the annulus. A mud pump is an important part of the equipment used for oil well drilling. The automatic valves of the fluid-end produce the pumping effect. The valves consist of a movable body and a reaction spring. The spring is designed in order to avoid leakage and prevent contact between the valve itself and the retaining cage. Its proper sizing depends on the operating conditions as well as the properties of the fluid. The valve seat geometry significantly contributes to ensure the tightness of the fluid-end. An aspect that should be carefully considered during the design of new geometries is the phenomenon of cavitation. Cavitation consists in the development of vapour cavities in the liquid phase. Inside the cavities the pressure is relatively low. When subjected to higher pressure, the voids implode and generate an intense shock wave that promotes the wear of the components (i.e. valve, valve seat, etc.). A deep understanding of the fluid behaviour is crucial for an effective design. Transient CFD simulations of the valve opening have been performed using a nonNewtonian fluid model able to describe the drilling muds. After a deep literature review, the Herschel– Bulkley model was selected as the most suitable for emulating the drilling mud. With the above mentioned approach, the reaction spring and valve seat were designed properly to avoid premature wear phenomena.

ANALYSIS OF AN AUTOMATIC VALVE GEOMETRY FOR CONCRETE AND DRILLING MUD PUMPS TO AVOID CAVITATION: NON-NEWTONIAN CFD MODELLING