English (United Kingdom)

https://curated-unify.zendy.io/wp-json/zendy-region/v1/featured_content/oa?rat=en

https://curated-unify.zendy.io/wp-json/zendy-region/v1/highlighted_journal/

Global: Zendy Plus annual

Presents the access of premium content as premium feature

Premium Content

Presents the keyphrase highlighting as premium feature

Keyphrase Highlighting

Presents the summarisation as premium feature

Summarisation

Insights

Presents the pdf analysis as premium feature

PDF Analysis

Presents the zaia usage as premium feature

ZAIA

Global: Zendy Tools annual

Global: Zendy Free Plan

Global: Zendy Tools monthly

Global: Zendy Plus monthly

Results of the investigation of volatile organic compounds emission during polyethylene extrusion are presented. Two polymers of different processing properties were tested, namely linear low density polyethylene (ExxonMobil) and high density polyethylene (Liten FB 29). Blowing film extrusion in experimental technological line using a single screw extruder as the imported element was done. VOCs were collected on sorbent tubes containing Tenax. Gas chromatography coupled with mass spectrometry (GC/MS) was applied for the identification of volatile degradation products. PE LLD material emits a significantly larger amount of hydrocarbons than PE-HD. Its emission contains mainly C18 and C20 hydrocarbons (alkanes, 1-alkenes, and α,ω-alkadienes). In case of the PE-HD polymer, lower degradation was observed and C18 and C23 hydrocarbons were emitted.

GC/MS analysis of gaseous degradation products formed during extrusion blow molding process of PE films