English (United Kingdom)

https://curated-unify.zendy.io/wp-json/zendy-region/v1/featured_content/oa?rat=en

https://curated-unify.zendy.io/wp-json/zendy-region/v1/highlighted_journal/

Global: Zendy Plus annual

Presents the access of premium content as premium feature

Premium Content

Presents the keyphrase highlighting as premium feature

Keyphrase Highlighting

Presents the summarisation as premium feature

Summarisation

Insights

Presents the pdf analysis as premium feature

PDF Analysis

Presents the zaia usage as premium feature

ZAIA

Global: Zendy Tools annual

Global: Zendy Free Plan

Global: Zendy Tools monthly

Global: Zendy Plus monthly

at 130°C to 250°C for 4houres. In result, over 150°C and with the exception of 100mass%BD, anodic oxide film was sealed by ZnAl2O4 spinel (ZAS) phase above 1mass% ZnAce, and by complex phase with ZAS and pseud-boehmite between 0.1 and 1mass% ZnAce, and by pseud-boehmite phase only without ZnAce. In the case of 100mass% BD, ZAS or pseud-boehmite was not produced, then, it was thought that these phases were prepared through dissolve/precipitation reaction of anodic oxide film by contained water. By means of SEM observation of cross-section of film, the film was composed of three layers, outer dense layer and a middle layer and inner columnar layer, or two layers, outer dense layer and inner columnar layers. Alkali resistance time of this film in 10mass% of NaOH aqueous solution by means of the electromotive force method (JIS H-8681-1) was 100-1000 times as long as the boiling water sealing film. The alkali resistance time increased with increasing of the dense layer thickness. From this result, it was thought that the effect of the ZAS phase sealing on alkali resistance was about 10-times bigger than the pseudboehmite phase sealing, and, the effect of the complex phase sealing was 4-times bigger than the pseud-boehmite phase sealing.

Autoclave Treatment of Anodic Oxide Film of Aluminum in Zinc Acetate Solution and Improvement of Alkali Resistance