English (United Kingdom)

https://curated-unify.zendy.io/wp-json/zendy-region/v1/featured_content/oa?rat=en

https://curated-unify.zendy.io/wp-json/zendy-region/v1/highlighted_journal/

Global: Zendy Plus annual

Presents the access of premium content as premium feature

Premium Content

Presents the keyphrase highlighting as premium feature

Keyphrase Highlighting

Presents the summarisation as premium feature

Summarisation

Insights

Presents the pdf analysis as premium feature

PDF Analysis

Presents the zaia usage as premium feature

ZAIA

Global: Zendy Tools annual

Global: Zendy Free Plan

Global: Zendy Tools monthly

Global: Zendy Plus monthly

In high strength 6000 series alloys dispersoids that form during heating to the homogenization temperature are used to improve fracture toughness and suppress grain growth during the extrusion process. However, these dispersoids can act as heterogeneous nucleation sites for nonhardening Mg-Si precipitates if quenching after extrusion is delayed. This leads to a reduced level of Mg and Si in solid solution and hence lower achievable strength and hardness. This phenomenon is called quench sensitivity. In this study, the hardening response of several 6000 series aluminium alloys is related to microstructural features, especially dispersoid density. Therefore, the alloys were quenched at varying rates after extrusion and age hardened to peak strength. Quench sensitivity is related to dispersoid density as well as to the enthalpy related to the precipitation of Mg-Si phase measured by DSC. The results suggest that in alloys containing dispersoids, quench sensitivity is primarily determined by the number density of dispersoids. However, effects associated with elements in solid solution cannot be ruled out. TEM investigations suggest that not only the general reduction of Mg and Si is responsible for the reduced mechanical properties, but that an inhomogeneous distribution of hardening precipitates might be another determining factor. [doi:10.2320/matertrans.L-MZ201111]

Relating Quench Sensitivity to Microstructure in 6000 Series Aluminium Alloys