English (United Kingdom)

https://curated-unify.zendy.io/wp-json/zendy-region/v1/featured_content/oa?rat=en

https://curated-unify.zendy.io/wp-json/zendy-region/v1/highlighted_journal/

Global: Zendy Tools annual

Presents the keyphrase highlighting as premium feature

Keyphrase Highlighting

Presents the summarisation as premium feature

Summarisation

Insights

Presents the pdf analysis as premium feature

PDF Analysis

Presents the zaia usage as premium feature

ZAIA

Global: Zendy Tools monthly

Global: Zendy Plus monthly

Presents the access of premium content as premium feature

Premium Content

Global: Zendy Plus annual

Global: Zendy Free Plan

In this study, we attempted to infiltrate molten magnesiumzinc (Mg6.2 massZn) alloy and magnesiumaluminum (Mg 8.3 massAl) alloy into titanium powder preforms using indirect selective laser sintering (SLS). It was observed that molten MgZn and MgAl alloys could easily infiltrate the Ti powder preforms during selfactivation at 973 K under argon atmosphere. In addition, all of the infiltrated sections of the preforms were found to exhibit excellent dimensional accuracy. The hardness and tensile strength of the infiltrated portions of MgZn were found to be 71 HRB and 333 MPa, respectively, and the corresponding values for MgAl alloy were 71 HRB and 343 MPa, respectively. The tensile strengths of the parts of the preform infiltrated with an alloy were significantly higher than those of the parts infiltrated with just Mg (241 MPa). We believe that the large increase in tensile strength after MgZn and MgAl infiltration is due to the interfacial reinforcement of the matrix and the generation of Tibased intermetallic phases, such as TiZn3, TiAl, and Ti3Al, on the surface of Ti particles as a result of their reaction with molten alloys. As a consequence of the reaction with molten alloys, the Zn or Al concentration in the infiltrated parts of the matrix was found to be lower than before infiltration. Thus, the infiltration of the MgZn and MgAl alloys into Ti powder preforms can be considered an effective indirect SLS technique for producing lightweight infiltrated metal alloy parts. [doi:10.2320/jinstmet.J2014006]

Infiltration of Magnesium-Zinc and Magnesium-Aluminum Alloys into Titanium Powder Preforms Using Indirect Selective Laser Sintering