English (United Kingdom)

https://curated-unify.zendy.io/wp-json/zendy-region/v1/featured_content/oa?rat=en

https://curated-unify.zendy.io/wp-json/zendy-region/v1/highlighted_journal/

Global: Zendy Plus annual

Presents the access of premium content as premium feature

Premium Content

Presents the keyphrase highlighting as premium feature

Keyphrase Highlighting

Presents the summarisation as premium feature

Summarisation

Insights

Presents the pdf analysis as premium feature

PDF Analysis

Presents the zaia usage as premium feature

ZAIA

Global: Zendy Tools annual

Global: Zendy Free Plan

Global: Zendy Tools monthly

Global: Zendy Plus monthly

Article is devoted to analysis of ECAP (Equal Channel Angular Pressing) method, which uses a high degree of deformation to achieve a very fine-grained structure of formed material. Utilization of The ECAP technology enables attainment of required properties of selected materials by using of severe plastic deformation (SPD methods). In the experimental part the influence of the number of passes through forming tool with classical geometry (angle of 90° between channels) was studied to achieve maximum hardening (expressed by deformation resistance and achieved value of hardness HV10). Also the metallographic analysis (detection of achieved grain refinement) was carried out. From comparison of results achieved at both alloys it can be stated that for given forming by ECAP method the EN AW-8006 alloy is preferable, because higher strength degree was obtained by achieving of very fine grained structure. When using the same method of forming by ECAP method the EN AW-2024 alloy has lower hardening and structure refinement. * Ing., Department of Mechanical Technology, Faculty of Mechanical Engineering, VŠB – Technical university of Ostrava, 17. listopadu 2172/15, Ostrava-Poruba, 708 33, Czech Republic, tel.: (+420) 59 732 9412, e-mail: ondrej.hilser@vsb.cz ** prof. Ing., CSc., Department of Mechanical Technology, Faculty of Mechanical Engineering, VŠB – Technical university of Ostrava, 17. listopadu 2172/15, Ostrava-Poruba, 708 33, Czech Republic, tel.: (+420) 59 732 3315, e-mail: stanislav.rusz@vsb.cz *** prof. Ing., CSc., Department of Mechanical Technology, Faculty of Mechanical Engineering, VŠB – Technical university of Ostrava, 17. listopadu 2172/15, Ostrava-Poruba, 708 33, Czech Republic, tel.: (+420) 59 732 3289, e-mail: radek.cada@vsb.cz **** Ing., Department of Mechanical Technology, Faculty of Mechanical Engineering, VŠB – Technical university of Ostrava, 17. listopadu 2172/15, Ostrava-Poruba, 708 33, Czech Republic, tel.: (+420) 59 732 9412, e-mail: michal.salajka@vsb.cz  prof. Ing.,D.Sc., Institute of Metallurgy and Materials Science, Polish Academy of Science, Reymonta street 25, Krakow, 30-059, Poland, tel.: (+48) 12 295 2861, e-mail: j.dutkiewicz@imim.pl

sborník vědeckých prací vysoké školy báňské-technické univerzity ostrava. řada strojní/transactions of the všb-technical university of ostrava, mechanical series

Influence of Severe Plastic Deformation on Mechanical Properties and Structure of Aluminium Alloys