English (United Kingdom)

https://curated-unify.zendy.io/wp-json/zendy-region/v1/featured_content/oa?rat=en

https://curated-unify.zendy.io/wp-json/zendy-region/v1/highlighted_journal/

Zendy Plus

Presents the access of premium content as premium feature

Premium Content

Presents the keyphrase highlighting as premium feature

Keyphrase Highlighting

Presents the summarisation as premium feature

Summarisation

Insights

Presents the pdf analysis as premium feature

PDF Analysis

Presents the zaia usage as premium feature

ZAIA

Zendy Tools

Zendy Open

Film cooling holes are distributed mainly on the surface of turbine blades, with center lines at angles to the tangential direction. These “inclined micro holes” (IMHs) are difficult to machine because of their extremely small diameters, the challenge of cutting metal materials, and the high requirements for machining quality/efficiency. To achieve machining of IMHs, we employed an electrochemical discharge drilling method. The recast layer, however, remained at the outlet of IMHs due to the turbulent flow field and short electrolysis time at the outlet. To improve further the processing quality of IMHs, step feedinging of electrode was used to prolong the electrolysis time (i.e., the tool electrode was stopped for a short time after penetrating the workpiece). Changing the feed rate and increasing the pause time of electrode (PToE) led to continuation of electrolysis after penetration of the electrode out of the IMH. Electrochemical dissolution around the IMH was sufficient to improve removal of the recast layer. Therefore, IMHs without a recast layer were obtained. Experiments with different PToE were carried out, and analyses of voltage waveforms, current waveforms, average diameter, IMH morphology, and elimination of the recast layer on IMH walls undertaken. Results showed that step feeding method could corrode the residual recast layer at the outlet of IMHs.

Electrochemical Discharge Drilling of Inclined Micro Holes with Step Feeding Method